Description

SKU: ATL029

Note：
1. The adapter is only suitable for passenger vehicles with 12V battery voltage and equipped with an OBDII diagnostic seat.
2. X-431G anti-theft key adapter can only be bound/unbound to the diagnostic equipment three times. Please be careful when unbinding/unbinding.

Requirements:
1. Equipment requirements: 431 products for Android devices such as PRO, X-431G anti-theft with key adapter
2. Software requirements: Volkswagen/Audi V28.55 and above

Main functions:
key matching, anti-theft type recognition, remote control matching, key chip reading and writing, anti-theft data reading, support vehicle expansion.

Supported Car Models:
X431G is suitable for the second, third, fourth and fifth generation anti-theft systems of Vol-k-swa-gen, Au-di, Sko-da, and SEAT models.
A1, A3, A4, A5, A6, A7, A8, Q3, Q5, Q7, R8, TT, BEETLE, CADDY, EOS, GOLF, JETTA, CC, PASSAT, PHANTON, POLO, SCIROCCO, SHARAN, TIGUAN, TOUAREG, TOURAN, BORA, MAGOTAN, LAVIDA, GRAN LAVIDA, CROSS LAVIDA, PHIDEON, FABIA, RAPID, OCTAVIA, SUPERB, etc., covering model years up to 2018 and over 90% of Volkswagen series. Later also supports some models of BMW.

Supported Anti-theft Types:
35XX, CDC24C32, CDC24C32A3TTR8, CDC24C64, MQB, NEC MQB, NEC24C32, NEC24C64, NEC24C64_14+, NEC24C64D, NEC24C64_A1, NEC24C64_Q3, RB4, RB8, Magneti Marelli 95320, Magneti Marelli 9S12, Magneti Marelli MEC95320, Magneti Marelli MQB, etc.

Introduction of anti-theft matching function:
1. In order to prevent the car from being used by illegal keys, the anti-theft key matching function enables the anti-theft control system on the car to identify and authorize the remote control keys before the car can be opened and used normally.
2. When replacing the ignition switch key, ignition switch, integrated instrument panel, engine control unit (ECU), body control module (BCM) and remote control battery, the city shall carry out anti-theft key matching.

Connection to use：
X-431 anti-theft key adapter provides a special programming cable, the connection method is as follows: Diagnostic equipment VCI (vehicle communication) connector: used to collect vehicle information and send it to the diagnostic equipment. The VCI connector may be different with different diagnostic equipment. Vehicle diagnosis seat: it is used to connect the vehicle diagnosis seat. For the specific position of the vehicle diagnosis seat, please refer to the diagnosis equipment manual X-431 Anti-theft Key Adapter: According to different application scenarios and software tips, place the key chip (naked chip) or car key in the key chip hole of the anti-theft programmer.

Package listing：
1 x Launch X431G X-Prog key programmer
1 x Cable set to connect cable